Magnetfilter

Friess Magnetic filter CC

The Friess magnetic filter CC is able to remove ferritic particles like iron, steel or stainless steel from all kind of process liquids. The Friess magnetic filter CC is designed for a continuous flow of up to 100 l/min. The Friess magnetic filter CC removes ferritic particles down to 1 µm. Expecially in process like grinding, honing or lapping particles may cause scratches on the surface or block thin nozzles or cause wear at pumps, valves and so on. In addition to that particles in coolant may cause growth of bacteria.


The housing of the magnetic filter CC is equipped with one magnetic rod. The magnetic rod is equipped with high efficient neodymium magnets with extremely high field force. The dirty liquid flows along the magnetic rod. The particles will be collected on the surface of the magnetic rod and the clean fluid flows to the outlet. The special designed flow inside the housing of the magnetic filter makes sure, that the liquid flows slowly along the magnetic rod. Even very small particles down to 1 µm and less will be attracted by the magnetic field and remain on the surface of the magnetic rod. In case that the magnetic filter rod is completely satisfied with dirt particles the flow through the magnetic filter is guaranteed.

The magnetic filter CC works without consumables and doesn't need additional energy. Once installed no further operation costs are necessary. Because of the special design of the magnetic filter CC it is not necessary to open the housing in order to clean the magnetic filter. In order to clean the magnetic filter close inlet and outlet valve. Then you pull the movalbe magnets inside the filter rod into top position. When opening the bottom drain valve the collected particles will be flushed out with some liquid. For further operation close the bottom outlet valve and push the magnets back into work position and open inlet and outlet valve.

ADVANTAGES:

  • Removes particles down to 1 µm
  • Easy cleaning with opening the filter housing
  • No consumables necessary
  • No additional energy necessary
  • Recycling of collected particles
  • Longer service life for coolant, washing water, grinding oil
  • Better surface quality 
  • Easy cleaning without opening the filter housing

MEDIA:

  • Coolant
  • Grinding oil
  • Processing oil
  • Hydraulic oil

TYPICAL APPLICATION:

  • Grinding
  • Honing
  • Eroding
  • Lapping
  • Washing
  • Pre-treatment
  • Hardening
  • Test-stand


Download Data sheet CC (PDF)

Technical data
FRIESS Magnetic filter CC


Water based liquid

Max. flow: 100 l/min
Temperature:  5 °C up to 60 °C
Dirt holding capacity: 0,8 kg
Max. pressure: 5 bar
Connection: 1" BSP

Oil based liquid

Max. flow: 50 l/min
Temperaturbe:  5 °C up to 60 °C
Dirt holding capacity: 0,8 kg
Max. pressure: 5 bar
Connection: 1" BSP

Contact us click here